Changing the opening direction of the doors
If you wish to change the opening side of the doors proceed as follows: 1... Open the freezer door. All the appliances have a ventilation socle at the bottom. Remove it pushing strongly on the central and upper part. The upper supports will be loosed takes the piece out. Then, take the hinge cover off the opposite side of the ventilation cover and place it as required. (see fig. 5). 2... Removing the central hinge: � Open both doors. � Remove the external pin and then close the freezer door. � Remove the other pin and close the fridge door. � Taking care the doors do not fall, pull them off till bolts are loose. � Put the doors carefully on the floor. 3... Chage the bolts of the upper and lower hinges to the opposite side. Change also the plastic covers of the central partition. 4... Change the door self-closing system, putting the freezer door�s on the fridge door and viceversa. 5... Fit the freezer door into the lower hinge bolt and put the central hinge into the door. 6... Fit the fridge door into the upper hinge bolt. Pulling both doors outwards, fit the central hinge bolt too. Place the doors. 7... Open the fridge door and screw the central hinge pin. Then, open the freezer door and screw the other pin. 8... Assemble socle keep the door open, close it up to the metallic part. Fit the two lower flaps of the plastic piece into the metallic one, press down wards the two upper hooks (without stopping pressing the socle). Push it to wards the metallic one till they fit perfectly. 9...Dismantle the vertical handles and assemble them in the opposite side. Cover the holes with the plastic lids that were situated where the handles are presently. Once finished make sure that all joints close perfectly well all around the door and check that the internal light turns off when the fridge door closes. (see Fig. 6) Fig. 5
