PANASONIC EP30004
Instrukcja Obsługi

TROUBLE SHOOTING
Problem Motor Noises � It sounds and feels like the massage heads are straining to get over wrinkles in the cloth. � The motor groans when it comes under load. � There is excessive noise during Tapping. (The noise is greater at the top of the massage lounger.) � There is a creaking noise when the massage heads are in operation. � There is a rattling sound when the massage heads move up or down. � The belt can be heard rotating. � There is a rubbing sound produced by the massage heads rubbing on the seat fabric. � There is a noise when the back cushion moves over the armrest when the seat is reclining. � There is a noise when I sit down. � There is a strange sound when the massage heads move in and out. � There is operational noise when applying air pressure. � There is a noise of discharging air. � The legrest rattles. � There is a humming sound from the pump. � There is operational noise of valves under the seat. � There is an unstable sound when air escapes during the leg stretch. The massage heads stop during operation. Cause and Remedy These sounds are perfectly normal and will not have any effect on the operation of the unit.

The massage heads do not come up to the shoulder or neck.

The height of the left and right massage heads is different.

If excessive force is applied to the massage heads during operation, in the interests of safety the massage heads may stop moving. If all markings and buttons on the control panel start to flash, which is extremely unusual, turn off the power switch, wait for approximately 10 seconds and then turn the power switch on again. If the massage heads stop again, position yourself so that your back is not completely in contact with the backrest. (Caution should be exercised particularly when used by persons weighing 220 lbs (100 kg) or more.) If your head does not contact the pillow or your back does not contact the backrest, the shoulder position may be detected as lower than the actual position during the body scanning. Sit on the seat in the deepest position and put your head on the pillow, and then repeat the operations again from the start. (See page 19) An alternating tapping method is employed, which means that this phenomenon will naturally occur. There is nothing wrong with the unit. If the unit encounters an obstacle or if excessive force is exerted on it during operation, in the interests of safety the unit will come to a stop. When all displays and buttons are flashing and the backrest or the legrest has stopped, turn off the power of the unit once, turn �on� the power again after approximately 10 seconds, and then operate the unit. In some cases the seat may not automatically recline depending on the position (angle) of the backrest or the legrest. If the unit is stopped by automatic shut-off or by pressing the button, it will not return automatically. (To return from the reclined position to the original position, press the twice.) button

It is not possible to recline the unit. The legrest cannot be raised or lowered.

Reclining does not take place even though a massage is started in pre-programs. (The seat does not automatically recline.) The backrest does not return to the upright position.

46