|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
13. ER-A8MR
* When installing the ER-A8MR, the ER-A7RS must be also installed. 1) Remove the rear cover and rear display. 2) Install the ER-A7RS. 3) Fix the MCR angle to the lower cabinet with two screw 1. 4) Attach the accessory holder A of the ER-A7RS to the lower cabinet. 5) Fix the MCR cable of the ER-A8MR with the holder. 6) Connect the MCR cable 2 to the ER-A7RS. 7) Be sure to pass the MCR cable along the back of the lower cabinet. 8) Install the rear display and the rear cover.
4) Fix the drawer cable with pin 3, and tighten the screw on the back of the lower cabinet. * Section A in the lower cabinet (between two projections on the lower cabinet) can be opened to make a hole with the screw. * When fixing pin 3, use the cable holder fixing screw (Parts code: XHPSC30908000) (accessory of the ER03DW/04DW/05DW).
1
2
1 A Holder (LHLDW6821BHZZ)
3
2
2
3
Fig. 12
A
14. ER-03DW/04DW/05DW
Fig. 14
ER-A03DW/04DW/05DW connection
5) Fix the gnd-wire 5 from ER-03DW/04DW/05DW with a screw on the option angle.
Fig. 13 1) Remove the rear cover and rear display. 2) Connect the drawer cable 1 to the drawer connector 2 on the main PWB. 3) Remove pin 3 attached to the lower cabinet.
5
GND-wire from ER-03DW/04DW/05DW
Fig. 15
�6�
|
