PANASONIC ES8807
Instrukcja Obsługi

Before use
This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this watertight shaver in the shower and clean it in water. The following is the symbol of Wet shaver. The symbol means that hand-held part may be used in a bath or shower.

Charging
Connect the power cord to the shaver, and plug the adaptor into an AC outlet. (see fig. 3) The shaver will be adjusted automatically to voltages between 100-240V AC. In some areas, a special plug adaptor may be required. � When charging the shaver for the first time or when it has not been in use for more than 6 months, the charge status lamp may not illuminate for a few minutes after operation. It will eventually illuminate if kept connected. Adequate ambient temperature for charging is between 15 to 35 °C. � If it is far below or over the appropriate temperature, the charging time may be extended, or the adaptor may not function. � In particular, low temperature may shor ten the life span of the rechargeable battery. In this case, the charge status lamp blinks twice in 1 second. The charge status lamp will glow when the shaver is being charged. The battery capacity monitor will fully illuminate and the charge status lamp will blink after charging is completed (see fig. 2). 10 minutes after charging is completed, the battery capacity monitor will extinguish and the charge status lamp will continue to blink (see fig. 2).

Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/ Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.

Parts identification
(see fig. 1) A Protective cap B System outer foil C D E F G H Inner blades System outer foil release buttons Battery capacity monitor Charge status lamp On/Off switch Trimmer

I Trimmer handle J Adaptor K Power cord READ ALL INSTRUCTIONS BEFORE USE.

7

7