WHIRLPOOL ET16JKXLWR0
Instrukcja Obsługi

Removing

the Light Shield.

You may want to remove the light shield when cleaning, or for changing the bulb. First, unplug the refrigerator. Then, push lightly On the upper center of the shield until the notched tab is free from the console. Pull down until the tab clears, then lift the back hooks out Of their slots. To replace it, do the reverse.
, Push In the Center; Pull Down

Removing

the Crispers

and Crisper

Covers.

Push the lab to Clear the Cover

To remove the crispers, slide them out until they stop. Lift the front a little and slide them the rest of the way out. Each cover is held in place by two pegs at the back and two notched tabs in the front. Press the tabs out of the way to lift the front. Litt the back off the pegs To put the covers back, replace the center leg. Replace each cover by first fitting the back notches over the pegs. Then push the front down into the notched tabs. The center leg can be made shorter or longer to help level the crisper covers, if necessary. Turn the leg clockwise to make it longer. Turn it counter-clockwise to shorten it.

Ice Cube

Trays.

Snap Back Into Place

To remove ice from the flexible ice trays, hold a tray at both ends, as shown. Slightly twist the tray; the ice will come out easily. If cubes are not used for a number of weeks, they may become smaller. The moving air is so cold that it starts a slow evaporation. [That�s also why it�s so important to wrap food carefully.) The longer they are stored, the smaller they can get.

Optional

ICE MAGIC�

Automatic

Ice Maker.

Raise Signal Arm to Stop Ice Maker. Lower Signal Arm to Start It.

If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-6), there are a few things you will want to know: l The ON/OFF lever is a wire signal arm. Down...for making ice automatically; Up...to shut off the ice maker. l Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. l It is normal for ice crescents to be attached by a corner.They will break apart easily l You will hear water running when Ice maker is working.You�ll hear ice fall into the bin. Don�t let these sounds bother You. l The ice maker will not operate until the freezer is cold enough to make ice.This can take overnight. l Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn l the Temperature Control toward a higher number. Wait a day and, if necessary, turn the Air Control toward A. If You remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They wilt be replaced. Cubes in the ice bin can also become smaller by evaporation

l

l