Removing and adjusting the freezer shelf...
To remove shelf: 1. Lift front slightly 2 Loftback off supports. 3 Replace in reverse order To adjust shelf: 1 Remove shelf 2 Remove supports by slrding upwards 3 Replace supports on desired level. 4 Replace shelf
Support
Ice cube trays.. .
If cubes are not used, they may shrink The moving cold arr starts a slow evaporatron The longer cubes are stored, the smaller they get To remove ice: 1 Hold tray at both ends. 2 Slrghtly twist
l
Optional automatic
ice maker.. .
If you have the automatic ice maker accessory or plan to add one later [Port No. ECKMF-83). there are a few things you will want to know: l The ON/OFF lever is a wire signal arm. Down...for making ice automatically, Up...toshut off the ice maker. l Shake the bin occasionally to keep cubes sepa rated, and to obtarn increased storage capacity On
l
l
l
It IS normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water runnrng when Ice maker is working. You�ll hear ice fall into the bin Don�t let these sounds bother you. The Ice maker WIII not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections. the first ice may be discolored or off-flavored Drscard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, If necessary. turn the Freezer Control toward A. If You remove the ice bin, raise the signal arm to shut off the Ice moker. When you return the bin. push It all the way in and lower the arm to the ON posItron. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes In the ice bin can also become smaller by evaporation. The ice maker water supply should not be softened water. The chemicals could damage the ice maker molds,
