WHIRLPOOL ET18DKXWW01
Instrukcja Obsługi

Ice compartment

door

Pull the ice compartment door panel out from the bottom and slide it to the rear.

Ice cube trays If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Twist slightly.

Optional Raise slgnal arm to stop ice. Lower signal arm to start it.
l

automatic

ice maker

If you if you there The l

have the automatic ice maker accessory, or plan to add one later (Part No. ECKMF-90) are a few things you will want to know: ON/OFF lever is a wire signal arm.

l

l

l

l

l

Down.. .for making ice automatically. Up...to shut off the ice maker. NOTE: Do not turn ice maker on until it is connected to the water supply. Instructions for ice maker water supply hook-up are attached to the back of the refrigerator cabinet. The dial or lever on the side of the ice maker changes the size of the cubes. Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer is cold enough to make Ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

9