WHIRLPOOL ET20GMXTN00
Instrukcja Obsługi

Changing the light bulbs...

2. Remove 3. Replace

bulb. with a 40.watt

appliance

bulb.

r..

./

_I z

.3lkkw

~~~~.�ii~.

Al

i.

^.

Removing the base grille...
To remove the grille:

r

7 SUPPORT TABS METAL CLIPS

1. Open the door. 2. Pull grille outwards as shown. 3. Do not remove Tech sheet fastened grille.

behind

1. Line up grille support tabs with metal 2. Push firmly to snap into place. 3. Close the door.

clips.

Ice cube trays...
(Model ETPOGK) To remove ice: If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. 1. Hold tray at both ends. 2. Slightly twist.

Automatic

ice maker...

If you have Model ET20GM and have the automatic ice maker accessory, or if you have Model ET20GK and plan to add one later (Part No. ECKMF-831, there are a few things you will want to know: l The ON/OFF lever is a wire signal arm. Downfor making ice automatically. Up...to shut off the ice maker. DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY. l The dial or lever on the side of the ice maker changes the size of the cubes. l Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. l It is normal for ice crescents to be attached by a corner. Thev will break abart easilv.
l

RAISE SIGNAL ARM TO STOP ICE

l

l

l

You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you.

The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. It ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A.