WHIRLPOOL ET20PKXTM01
Instrukcja Obsługi

1. Reach behind the control console 2. Remove bulb. 3. Replace with a 40-watt appliance

to find bulbs. bulb.

Removing the base grille...
To remove

METAL CLIPS

the arille:

r
SUPPORT TABS

SUPPORT TABS

1. Open the door. 2. Pull grille outwards as shown. 3. Do not remove Tech Sheet fastened grille.

behind

To replace the grille: 1. Line up grille support tabs with metal 2. Push firmly to snap into place. 3. Close the door.

clips.

Ice cube trays...
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. ? EE:i?both 2. Slightly twist. ends

Optional

automatic ice maker...

l

If you have the automatic ice maker accessory, or if YOU plan to add one later (Part No. ECKMF-831, there are a few things you will want to know:
l

l

The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A. If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation. Good water quality is important for good ice quality. It is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly.

The ON/OFF lever is a wire signal arm. Downfor making ice automatically. Up...to shut off the ice maker. DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY. The dial or lever on the side of the ice maker changes the size of the cubes Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity It is normal for ice crescents to be attached by a corner. They will break apart easily.

l

l

l

l

l

l

l

LOWER SIGNAL ARMTO : START IT
l

You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you.

7