Removing- the base grille... To remove the grille: r
METAL CLIPS -I SUPPORT TABS
1. Open the door. 2. Pull grille outwards as shown. 3. Do not remove Tech sheet fastened grille.
behind
To replace the grille: 1. Line up grille support tabs with metal 2. Push firmly to snap into place. 3. Close the door
clips.
Ice compartment
door.. .
Pull the Ice compartment door panel bottom and slide it to the rear
out from the
Ice cube trays...
(Model ETZORK only) If cubes are not used, they may shrink The movrng cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Slightly twist.
Automatic
ice maker...
If you have Model ET20RM with the automatic ice maker accessory, or if you have Model ET20RK and plan to add one later (Part No. ECKMF-831, there are a few things you will want to know:
l
l
LOWER SIGNAL ARM TO START IT
l
l
The dial or lever on the side of the ice maker changes the size of the cubes. Shake the bin occasionally to keep cubes separated, and to obtain increased storage CapaCitY It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer IS cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A
l
l
The ON/OFF lever is a wire signal arm Down...for making ice automatically. Up...to shut off the ice maker. DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY.
