INSTALLATION Technical information for the installer
Before installing the hob, remove the protective film. This cooktop can be fitted into a work surface 20 to 40 mm thick (ETN 4240) or 30 to 40 mm thick (ETK 4240) and 600 mm deep. To fit the hob into the unit make an opening of the dimensions given in the figure, remembering that: - inside the unit there must be a space of at least 30 mm between the bottom of the hob and the top of an appliance or bracket. - any wall to the side and above the hob must be at least 50 mm away. - the wall behind the hob must be at least 50 mm away. - when there is a wall unit or hood above the hob there must be at least 650 mm between the hob and the unit or hood. - the coatings of the walls of the unit or appliances near the hob must be heat resistant (�Y� protection against heating in compliance with standards EN 60335-2 6). Do not install the hob near inflammable materials (e.g. curtains).
