Using Your Freezer Continued The trivet Store small packages in basket to avoid losing them in bottom of freezer. To remove: 1. Lift front of trivet out of supports 2. Pull out. To replace: I. Position back of trivet on the rear wall supports. 2. Lower front into place. The key eject lock If your freezer is equipped with a lock, it can help reduce the hazard of child entrapment. To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock If the key is lost, contact your Whirlpool dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key. The interior light
Electrical Shock Hazard Before removing a light bulb, either unplug the freezer or disconnect the electricity leading to the freezer at the main power supply. Shock and injury can occur if electricity remains connected. Light shield To replace the light:
1. Remove the light shield from the side of the control panel. Depress the back of the shield to release the tabs, then pull away. 2. Replace the bulb with a 40-watt appliance bulb. 3. Replace the light shield. Insert the shield tabs in the slots, then press the shield to snap into place. The signal light The signal light automatically warns of any unexpected power failure. If the signal light is not glowing, immediately check for power interruption, an unplugged power cord or a burned out signal light. To replace signal light: 1. Unplug power cord from outlet. 2. Open the freezer door. 3. Push out signal light from behind, then unplug burned out light. Replace with a new one. Signal light can be ordered from your Whirlpool dealer, Part No. 1103639 (EVl SOFXS) or Part No. 1103680 (EVl SOFXS). 4. Close freezer door and plug power cord into outlet.
