WHIRLPOOL EV150CXKW2
Instrukcja Obsługi

Before you plug it in
Before using your freezer, you are personally responsible for making sure that it... l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l

0 is properly matntained. is in a tlry sheltered place. l
l

is connected

only to the right kind of outlet,

l l

is usec in an area where the room temperature wi I not exceed 110 F (43.3-C). is not rlAn where there are explosive fumes. is not used by children or others who may not understand how it should be used. is not IL,,aded with food before it has time to get prc:perly cold.

l

l

with the right electrical supply and grounding. is used only for jobs expected of home freezers. is not near an oven, radiator or other heat source.

l

Install

Properly..

.

level

Freezer.. .

6
3 inches above

so that (door will stay open at any position. 1. Startin� with door hinge side, turn left to raise cornet��_, !V &Zj� �:& � ; 2. Turn right to lower corner. +:;&& 3. ChecC with level. ~~~~~~~~ ,$ $P.P~. 4. After freezer is loaded :,: ;~$$$j .3s with food, recheck level. with a

1 inch in back1

Raise

Lower

Clean

It...
using it. See clean-

Clean jour freezer before ing instructions on page 4.

I

I. Check the strength of the floor. It should hold the weight of fully loaded freezer. 2. Pick a safe place, indoors, away from inflammables such as gasoline. 3. Allow at least 3 inches (7.5 cm] air space on top of freezer; 1 inch (2.5 cm] at back between condenser and wall and 112 inch (1.25 cm) at each side. 4. The four bolts that held your freezer in the shipping crate are designed to be leveling legs. Screw them far enough into the bolt holes in the four corners of the bottom of the freezer so the freezer stands about 1 inch (2.5 cm] off the floor.

Plug It Iln...
J-prong grounding type wall receptacle

Freezer power coE+J

Grounding Method

Recommended

Remove

Sales labels...

Remove the Consumer Buy Guide label and any inside labels before using the freezer. Remove any left over glue with rubbing alcohol.

I
2

Note: tened

DO NOT REMOVE the Tech Sheet fasunderneath cabinet.

I

A 120 Volt, 60 Hz., AC only, 15 ampere fused electrica supply is required. It is recommended that a separate circuit serving only this appliance be provided. The receptacle should not be controlled by a wall switch or pull chain. Do not Iuse an extension cord. See indrvidual electrical requirements and groundin instruction sheet in your literature package