Removing the bottom trivet...
To remove: 1 Lift front of trivet out of supports 2 Pull out To replace: 1 Posrtfon back of trivet on the rear wall supports 2 Lower front lr,to place
Lift the Front, Then Pull Out.
The key eject lock...
can help entrapment reduce the hazard / of chfld To lock or unlock the freezer you must hold the key In the lock while turning The lock IS spring loaded so the key cannot be left in the lock If the key IS lost, contact your WHIRLPOOL dealer for a replacement Always give the complete model and serial number of your freezer when requesting a replacement key.
The signal light...
automatfcally power failure warns of any unexpected
Signal /
Light
If the signal light is not glowing. fmmediately 0 for power interruption, l for an unplugged power cord, l for a burned out signal light
check
To replace burned out signal light: 1 Unplug power cord from outlet. 2 Open the freezer door 3 Push out signal light from behind, then unplug burned out light. Replace light with one of the same wattage and size. Signal light can be ordered from your WHIRLPOOL dealer, Part No. 1103639 4 Close freezer door and plug power cord into outlet.
Energy saving tips...
l
l l
You can help your freezer use less electricity Check door gasket and level freezer to assure a good door seal Clean the condenser coils regularly Keep door openings to a minimum Remove several Items at one ttme Keep contents organized to elrmrnote searching FIII to capacity Follow recommended procedures for freezing foods See pages 8 and 9
l
l l
Set Temperature Control to provide temperatures around 0 F [ 17 8 C] There IS no need to store foods below 0 F Keep door looked to ensure door closure Do not let frost bufld up to more than % Inch (6 mm) thick Efficiency IS reduced Keep Power Saving Control on OFF when humidfty IS low
