SONY EVIG20
Instrukcja Obsługi

Using the camera
POWER

1

After using the camera Press the POWER switch on the remote commander. The camera is then in standby status.

2
PRESET

HOME

T
ZOOM

W
HOME

POWER

POWER

T
ZOOM

1 2 3

AUTO

FAR

FOCUS
RESET MANUAL NEAR

The effective area of the remote commander Use the remote commander within the area illustrated below and aim at the receptor of the camera with the remote commander to remote control the camera.
Receptor

BACK LIGHT

POSITION

1

Turning on the camera Press the POWER switch at the rear of the camera to turn on the camera. The main power turns on and you can control the camera with the remote commander. When the main power is on, press the POWER switch on the remote commander to turn on the camera or set the camera to standby status.

5m 30° 15° 30° 15°

Do not apply mechanical shock to the camera when the camera is on The camera may not move even if you press the pan/ tilt buttons. In this case, press the POWER switch on the remote commander or the POWER switch at the rear of the camera to turn off the camera and press the switch again to turn it on.
Lighting up

When the camera is not in use for an extended period of time Press the POWER switch at the rear of the camera to turn off the camera. The main power turns off. In this setting, the remote control cannot operate the camera.

2

Adjusting the direction of the camera Press the pan/tilt buttons to adjust the direction of the camera. Press the pan/tilt button of the desired direction as you check the picture on the screen.
HOME button The camera turns to the front.
PRESET
POWER

HOME

T
ZOOM

W

1 2 3

AUTO

FAR

Pan/tilt buttons
RESET POSITION

FOCUS
MANUAL NEAR

BACK LIGHT

Note
When you press the POWER switch at the rear of the camera to turn off the camera, the preset memory is erased.

4