Operating sequence Automatic washing plus drying (NON-STOP operation)
This option is only possible for cottons and synthetics. Maximum load: � cotton, linen 3 kg � synthetics 2 kg Important: Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
5 Select the drying time
Turn the selector dial clockwise to the required time (light blue or yellow sector, depending on the type of fabric).
6 Select the temperature
95°
Turn the selector dial to the required temperature setting.
Place the laundry in the drum
Open the door and place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
P0881
7 Select the programme and start it
Turn the programme selector dial clockwise to the required wash programme and press the start/stop button : the operating light comes on and the machine starts to operate.
A
P0004
2 Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out P0876 the extra prewash, pour detergent into the appropriate compartment marked .
P0882
P0080
8 At the end of the programme
The machine stops automatically. It is normal to have to wait for about 2 minutes before being able to open the door to allow the safety lock to release. Press the start/stop button ing pilot light goes out. Remove the laundry. again and the operat-
3 Measure out the additive
If required, pour fabric softener into the compartment marked without exceeding the «MAX» mark.
Turn the drum by hand to make sure it is completely empty, so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites. Release any buttons which have been pressed. Turn the water tap off and unplug the machine. Leave the door ajar to air the machine.
