INSTALLATION
Transit devices
All transit bolts and packing must be removed before using the appliance. Proceed as follows: Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.
Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
P0255
P1051
2
1
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread after having inserted the small filter �A� supplied with the machine. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
P0647
P0233
Remove the polystyrene blocks from the underside of the machine and release the two plastic bags by removing the adhesive strip. Carefully remove the right-hand bag (1) then the lefthand bag (2) by pulling them towards the centre of the machine.
A
P0003
P0021
P0256
P0020
Set the machine upright and remove the two remaining bolts from the back. Pull out the three plastic pegs from the holes into which the bolts were fitted. Plug the open holes with the plugs which you will find at the back of the appliance. Note: You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
