6. Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted with the adhesive tape on the door seal.
Accurate levelling prevents vibration, noise and displacement of the machine during operation.Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
HEC0010
7. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.
HEC007S
Water inlet An inlet hose is supplied and can been found inside the machine drum. Do not use already employed hoses for water connections. 1. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled connection to the machine.
HEC0005
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner.
Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.
HEC0006
3. Set the hose correctly by loosening the ring nut.
