Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
EWF860_EU_Thailand.qxp
5/25/2006
12:04 PM
Page 14
7. Start the programme
To start the selected programme, press the Start/Pause button; the corresponding light stops flashing. The �in Progress� light illuminates. The machine starts operating.
If you cannot open the door but you need to open it you have to switch the machine off by turning the programme selector dial to �O�. After about 3 minutes the door can be opened (pay attention to the water level and temperature!). Select the programme again and depress Start/Pause to restart it.
12. At the end of the programme
Start/ Pause
The machine stops automatically. If the Rinse Hold option has been selected, the �End� and �Door� phase lights are on to indicate that the water must be emptied out before opening the door. To do this first turn the programme selector dial to �O� and then to drain programme or spin programme . The spin programme is performed at the maximum speed. In order to avoid any creasing or damage in synthetic, delicate, hand wash and wool items, the spin speed must be reduced by means of the relevant button. The door can only be opened after the Door light has gone out. Release of the lock is also indicated by the coming on of the End light. At the end of the programme turn the programme selector dial to �O� to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
8. Altering a programme
You can alter the programme before it starts. When the programme has started, you can only reset it by turning the programme selector dial to O and then you can select the new programme. The washing water remains in the tub. Start the new programme by depressing the Start/Pause button.
9. Interrupting a programme
Depress the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.
10. Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. Now you can select a new programme.
11. Opening the door after the programme has started
First set the machine to PAUSE by pressing the Start/Pause button. The door can be opened when the Door light has gone out. If the door does not open, this means that the water temperature is above 55°C, that the water level is above the bottom edge of the door or that the drum is turning.
