Starting a dishwashing cycle
0 1. Check that dishes and cutlery are arranged in the dishwasher so that
the spray arms can turn freely. 2. Turn the water tap on fully. 3. Press the ON/OFF button. The LED indicators of all the buttons on the control panel that can now be selected light up. 4. Press the programme button for the required cycle (see �Cycle table�). The programme indicator comes on. The remaining time expected for the cycle will be shown in the multidisplay.
3
This remaining time may be adjusted according to the size of the load, degree of soiling, etc. 5. Close the dishwasher door. The dishwasher cycle starts. A light signal in the form of a dot appears at floor level. If the dishwasher is built in at high level with flush fitting cupboard doors, the light signal cannot be seen. The dot shaped light signal is not dangerous. (It is not a laser.) It is lit while a dishwasher cycle is running and goes out when the cycle ends. If after the start of the cycle fault codes are displayed in the multi-display and/or acoustic fault codes can be heard, please read the section �What to do, if ��
3 3 3
Changing/interrupting/cancelling a dishwasher cycle
3
Only change or interrupt a dishwashing cycle that is in progress if it is absolutely necessary. After the appliance is closed again, the air that has entered is heated up to a high degree and expands. This can allow water into the bottom reservoir and may trigger the anti-flood system. Changing a dishwasher cycle
3
If you want to change the dishwasher cycle before closing the dishwasher door, briefly press the button for the new dishwasher cycle. If you want to change the dishwasher cycle after the cycle has started, proceed as follows:
