7. Select the DELAY START
Before you start the programme, if you wish the starting to be delayed, press the DELAY START button repeatedly, to select the desired delay. The relevant light illuminates.
10. Interrupting a programme
Depress the START/PAUSE button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.
12 h DELAY START
9h 6h 3h
11. Cancelling a programme
Turn the selector dial to O to cancel a programme which is running. Now you can select a new programme.
12. Opening the door after the programme has started 8. Start the programme
To start the selected programme, press the START/PAUSE button, the corresponding light stops flashing. The IN PROGRESS light illuminates. First set the machine to PAUSE by pressing the START/PAUSE button. If the door does not open, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to O. After about 3 minutes the door can be opened (pay attention to the water level and temperature!).
START/ PA U S E
13 At the end of the programme
The machine stops automatically, the END pilot light goes on and the door can be open. If you have chosen a delayed start, the machine will begin the countdown. Switch the machine off by turning the programme selector dial to O. Remove the laundry from the drum and carefully check that the drum is empty so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
9. Altering an option or a programme
Before you make any change, you must pause the washing machine by pressing the START/PAUSE button. It is possible to change any phase before the programme carries it out. When the programme has started, you can only reset it by turning the programme selector dial to O and then you can select the new programme. The washing water remains in the tub. Start the new programme by depressing the START/PAUSE button. Note: To drain the water before starting the new cycle, you have to cancel the programme and select the �Q� (DRAIN) cycle.
