Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
Operating sequence
Before washing your first load of laundry, we recommend that you run a cotton cycle, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
4. Select the option push button/s 5. Select the programme and start the machine
Turn the programme selector dial clockwise to the required programme. Before pulling the On/off programme selector check if: � The door is properly closed. � The appliance is plugged in. � The water supply tap is turned on. � The diaphragm lid is correctly screwed into place. � The drain hose is adequately positioned. Pull the program dial up to you till it klicks. The pilot light comes on and the program will begin.
1. Place the laundry in the drum
Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
B
B
P0004
R0033
R0033 B
6. At the end of the programme 2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out the prewash, pour detergent into the appropriate compartment marked . The machine stops automatically. The mains on light goes out. If you have selected a programme which ends with the water of the last rinse left in the tub, drain the water before opening the door. Select programme �L� (drain) or �F� (spin). Wait one or two minutes before opening the door to give the electric locking mechanism time to release it. Remove the laundry. Turn the drum by hand to make sure it is completely empty, so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites. Release any buttons which have been pressed. Turn the water tap off and unplug the machine. Leave the door ajar to air the machine.
3. Measure out the additives
If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.
