BROTHER FAX290MC
Instrukcja Serwisowa

(8)

For the FAX-270MC/290MC/520DT/520MC/MFC370MC/390MC: Take out the microphone* and its harness* from the control panel.
Bosses

Main-mike harness*

Latches

Control panel

* Provided on the FAX-270MC/290MC/520DT/520MC/ MFC370MC/390MC.

(9)

To take out the LCD, remove the control panel PCB and the FPC key in step (6). As shown below, insert the tip of a flat screwdriver under clamp �D� in the direction of arrow F and push up clamp �D� slightly to release the LCD from clamp �C.� In the same way, insert the screwdriver under clamp �A� to release the LCD from clamp �B.� Then push out the LCD with your fingers in the direction of arrow R.

F

"A" Flat screwdriver

R

"B"

LCD F (Rear) "C" R "D"

s Reassembling Notes � To put the LCD back into place, insert the tip of a flat screwdriver under clamp �D� (see the above illustration) in the direction of arrow R, push up clamp �D� slightly, and then put the right edge of the LCD under clamp �D.� In the same way, insert the screwdriver under clamp �A� to put the left edge of the LCD under clamp �A.� Then push the LCD into place with your fingers in the direction of arrow F. � � When installing the LCD, take care not to scratch or damage the cover sheet. Replace it if scratched or damaged. A new LCD is covered with a protection sheet. Before installing it, remove the protection sheet.

IV � 12