Wszystko OK!
Dokumentacja jest czytelna.
Dziękuję.
Tekstowy podgląd strony 84 (kliknij aby zobaczyć)
FH-P8800
- Removing the upper block of the CD mech module
1. Remove the 4 screws and the connector. Then take out the CD Mechnism Module. (Not shown in the figure). 2. Remove the 7 screws and the Heat Sink. 3. Remove the 7 screws and the connector. Lift the CD section together with the Cassette Mechanism
Module upwards, and remove it.
Heat Sink
CD Section CD Power Unit
Cassette Mechanism
Audio Amp Unit - Removing the CD power unit
1. Remove the 3 screws. 2. Straighten the 4 hooks marked with an arrow. Remove the CD Power Unit. When connecting the Deck Unit (Cassette Mechanism Module) to the Audio Amp Unit, push the Deck Unit through the hole by hand to insert the connector.
