WHIRLPOOL FL 5045
Instrukcja Obsługi

CONSUMPTION DATA Temperature Selector (°C) Cotton with prewash Cotton Cotton Synthetics Cotton short Synthetics short Delicate Wool 95 95 60 60 40 40 40 40 Load Water Energy Estimated Programme Duration Min. 120 110 110 85 75 75 70 65

PROGRAMME END 1. At the end of the programme the programme selector moves to the stop position. 2. To unload the washing machine wait for the door to unlock (about 2 minutes). 3. Switch off the washing machine, open the door and take out the laundry. 4. Close the tap and leave the door ajar to allow the drum to dry out. NOTES AND INDICATIONS FOR USE Water level To obtain low water consumption without compromising washing results the water level within the drum may not be visible. Cleaning the pump filter A regular filter check and eventual cleaning is advisable. Motor smell Washing machine motor creates a typical electrical smell during first cycles, this is normal and disappears after a few cycles.

Programme

(kg) 5.0 5.0 5.0 2.0 2.5 2.5 1.5 1.0

(l) 80 70 70 60 65 60 80 80

(kWh) 2.00 1.80 1.20 0.90 0.70 0.60 0.60 0.60

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy label refer to the programme Cotton 60°C.

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter �Detergents and Additives� in the booklet. 1. Open the tap. 2. Set the programme selector to the desired programme. 3. Set the temperature selector to the desired temperature. 4. Special options can be selected. 5. Check that the door is well closed and turn on the washing machine by pressing the �ON/OFF� button. The indicator lights up, indicating that the washing machine is on.

SELECT ANY DESIRED OPTION �Half Load� button � Reduces water consumption, above all during rinsing. Suitable for lightly-soiled laundry and small loads (max 3 kg). �No Spin� button � Excludes spinning from programme, press button. Suitable for delicate laundry. Note: with the �Cotton� and �Synthetic� programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results. PROGRAMME CHANGE To reselect a programme when a cycle has already started: 1. Switch off the appliance by pressing the �ON/OFF� button. 2. Select the new programme, temperature and options. 3. Start the programme by pressing the �ON/OFF� button again.

Whirlpool is a registered trademark of Whirlpool USA

5019 301 10197