Operating sequence
Important: Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
5 Select the temperature
Press the temperature selector dial in to pop it out and turn it to the required value.
90°
1 Place the laundry in the drum
Open the door and place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
P0999
6 Select the programme and start the machine
Press the programme selector dial in to pop it out and then turn it clockwise until the programme coincides with the marker.
P0004
B
2 Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out the prewash, pour detergent into the appropriate compartment marked .
P0413
P0129
P0517
Depress the ON/OFF button: the operating pilot light will come on and the machine starts operating.
3 Measure out the additives
If required, pour fabric softener into the compartment marked , and bleach into the compartment marked without exceeding the «MAX» mark.
7 At the end of the programme
The machine stops automatically, the operating light goes out. After a programme which stops with water in the drum (button pressed), the water must be emptied out before opening the door. Wait one or two minutes before opening the door to give the electric locking mechanism time to release it. Relase the ON/OFF button. Remove the laundry. Turn the drum by hand to make sure it is completely empty, so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites. Release any buttons which have been pressed. Turn the water tap off and unplug the machine. Leave the door ajar to air the machine.
