|
Dla tego produktu nie napisano jeszcze recenzji!
Quick Reference Guide
5. Cut the band which holds the spools 8. Wind the film slightly (rotate the gear
together with scissors, and remove it. Insert the remaining gear into the right end of the empty spool and the flange into the left end of the empty spool. Make sure the tabs on the gear and the flange fit into the slots in the ends of the spool (the gear has two tabs and the flange has one tab). 1 tab 2 tabs
on the right side of the empty spool) so that there is no slack in the film. Make sure that both edges of the film wind onto the spool evenly.
9. Close the print compartment cover, making sure it clicks into place.
� Caution!
Gear Flange
6. Pull the empty spool toward the back of
Close the cover slowly to make sure it doesn't pinch your fingers.
the compartment, unwinding the film as you pull.
10. Load paper in the paper tray and then press the following keys to initialize the film.
� Note: Paper must be loaded before the
7.Insert the empty spool into the back of
FUNCTION
film can be initialized. To load paper, see Loading the Printing Paper.
the compartment so that the gear and the flange fit into the slots on the sides of the compartment.
6
START
INITIALIZE FILM
� Make sure that the gear engages with the
gear below it.
50
|
