Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 22 (kliknij aby zobaczyć)
Loading copy paper
1 1
1
Hold the paper tray so that the paper guide of the paper tray is facing front and then insert the paper tray into the copier�s paper tray slots.
2
Pull the paper release lever located at the back of the copier. If the paper is inserted without doing this, paper misfeeds will occur.
Paper tray
View from the back of the machine
Paper release lever
3
If extra long paper is used, raise the paper support to support the paper. Fan the copy paper and place it into the paper tray with the side to be printed facing toward you. Position the paper along the right end of the paper tray. Then adjust the paper guide to the paper width.
� The paper tray holds up to 250 sheets of standard paper (56 to 80 g/
m²). Do not set too many sheets. � Feed copy paper lengthwise only. � When copying onto special paper such as labels and transparency film, feed one sheet at a time.
� When copying onto an envelope, insert it so that the side to be printed
on is facing upwards and so that the flap on the reverse side is at the right when looking from the front of the copier. Leave a gap of approximately 1 mm between the paper guide and the left edge of the envelope. � When loading an envelope, make surre that it is straight and flat.
