NEC FP1350
Instrukcja Serwisowa

f. Open Menu(S), TAG C "H.CONVER PARA B", and adjusted so that misconvergence of the horizontal direction may become the minimum in M of the Fig 10-7 and N and O point. Open Menu(S), TAG C "V.CONVER PARA B", and adjusted so that misconvergence of the vertical direction may become minimum.

Ｂ Ｒ ＲＢ ＲＢ H.CONVER PARA B V.CONVER PARA B

Fig 10-5 The move of the R line and the B line when "H./V. CONVER PARA B" was moved in the + direction. 3) Measure misconvergence, by using following standards mentioned below. Adjusted to satisfy the standard of the Xv revision Coil on DY, XH slider ,Blue-BOW revision ring, 6-pole magnets on the CPM, spoiler magnet. * The installation lie of each VR and slider is shown in the Fig. 10-8,and actuation is shown in the Fig.10-9. * There is a deflecting yoke in a point to install the XH slider from side to side to side. When it was imported in the left viewed from the screen side, Demonstrated in Fig.10-9-c. When it was imported in the right viewed from the screen side, Demonstrated in Fig.10-9-d. The value of standards : x , y � 0.30mm

XV-COIL

TRD(LR) Yh

4-pole magnets 6-pole magnets Fig 10-4 The location of the VR. and Coil and magnets