jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 83 (kliknij aby zobaczyć)
f. Open Menu(S), TAG C "H.CONVER PARA B", and adjusted so that misconvergence of the horizontal direction may become the minimum in M of the Fig 10-7 and N and O point. Open Menu(S), TAG C "V.CONVER PARA B", and adjusted so that misconvergence of the vertical direction may become minimum.
Ｂ Ｒ ＲＢ ＲＢ H.CONVER PARA B V.CONVER PARA B
Fig 10-5 The move of the R line and the B line when "H./V. CONVER PARA B" was moved in the + direction. 3) Measure misconvergence, by using following standards mentioned below. Adjusted to satisfy the standard of the Xv revision Coil on DY, XH slider ,Blue-BOW revision ring, 6-pole magnets on the CPM, spoiler magnet. * The installation lie of each VR and slider is shown in the Fig. 10-8,and actuation is shown in the Fig.10-9. * There is a deflecting yoke in a point to install the XH slider from side to side to side. When it was imported in the left viewed from the screen side, Demonstrated in Fig.10-9-c. When it was imported in the right viewed from the screen side, Demonstrated in Fig.10-9-d. The value of standards : x , y � 0.30mm
XV-COIL
TRD(LR) Yh
4-pole magnets 6-pole magnets Fig 10-4 The location of the VR. and Coil and magnets
