jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
1. Turn off the main switch. 2. Remove the rear cover (4 screws). 3. Unhook the spring [A] from the tension pulley bracket [B]. 4. Remove the drive belt [C] from the drive pulley [D]; then remove the pulley (1 E-ring). 5. Remove the 3rd paper feed clutch bracket [E] (2 E-rings and bushings and 3 screws). 6. Replace the 3rd paper feed clutch [F] (1 connector). NOTE: a) When the clutch is installed, make sure that the stopper [G] on the bracket fits into the slot on the clutch as shown. b) When the clutch is installed, make sure that the 3rd feed rollers are facing up. If not, rotate the shaft [H]. c) When the drive belt is installed, make sure that the belt stoppers [I] of the drive pulleys are positioned correctly as shown. This is to prevent the drive belt from coming off the pulleys.
Replacement Adjustment
