ZOOM GFX-707
Instrukcja Obsługi

5

Use parameter knobs 1 - 3 to change the parameter setting.
In edit mode, the parameter knobs 1 - 3 serve to adjust the parameters 1 - 3 of the currently selected module. When one of parameter knobs 1 - 3 is turned, the name of the corresponding parameter appears on the display and the current value on the BANK/PATCH indicator. For example, if the effect type ROOM of the REV module is selected, the parameter knobs 1 - 3 will adjust the following parameters.

TYPE (BANK)

PATCH NAME

BANK

PATCH

(GROUP)
BOTH

(VALUE)

EDITED

First push
TYPE (BANK)
PATCH NAME BANK PATCH

(GROUP)
BOTH

(VALUE)

EDITED

Second push
TYPE (BANK)
PATCH NAME BANK PATCH

(GROUP)

BOTH

(VALUE)

EDITED

Third push

6

To switch the ON/OFF status of a module, press the MODULE / keys together. Repeat steps 3 - 6 to edit other modules When editing is completed, press the EDIT (CANCEL) key.
The GFX-707 returns to the play mode. A dot (.) appears at the "EDITED" position of the BANK/PATCH indicator, to indicate that the patch has been edited.

7
� Parameter knob 1 � Parameter knob 1 � Parameter knob 1
Altering the Sound of a Patch (Edit Mode Operation)
� � � � � � TIME � � � � � � TONE � � � � � � MIX

8

To check the value of a parameter without moving the parameter knob, press the TYPE (BANK) w/v keys together. With each push of the two keys, the names of parameters 1 - 3 and the respective settings are shown.

Storing and Copying Patches
Unless you store an edited patch in the memory of the unit, the edited contents will be lost (the patch will revert to its original condition) when you select another patch. If you have created a patch you like, do not forget to store it. It is also possible to store an existing patch in another location, thereby creating a copy. By copying several patches you want to use in a song to adjacent numbers in the USER group, you can easily call them up during a performance.

1

In play mode or edit mode, press the STORE key.
The GFX-707 enters the store standby condition. If the STORE key is pressed while using the rhythm function, the rhythm output is stopped and the unit then enters the standby condition. When storing an edited patch, be sure to change the patch name. This is done with the TOTAL module ( p. 20).

flashing alternately on the display.
PATCH NAME BANK PATCH

BOTH

(VALUE)

EDITED

3

To execute the patch store (copy) process, press the STORE key once more.
Storing is carried out, and the unit returns to the play mode. To abort the store process, press the EDIT (CANCEL) key before step 3.
� The PRESET group is read-only. If a patch from the PRESET group was selected and the STORE key is pressed, the store target automatically becomes "A1". Change the bank/patch number as required. � When store (copy) is carried out, the previous patch in the target is overwritten (erased). If that patch was edited, its contents cannot be restored. However, it is possible to restore a selected patch or all patches from the USER group ( p. 23) to the factory defaults.

2

Use the TYPE (BANK) w/v keys and w/v foot switches to select the store target (copy target).
If you do not specify the store target, the original bank/patch number becomes the store target. When you change the store target bank/patch number, the changed portion on the BANK/PATCH indicator flashes. The indication "STORE?" and the store target patch name are
NOTE

16

ZOOM GFX-707