Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
FRONT PANEL FACILITIES
3
Equalizer ON indicator
1
Left channel Equalizer indicators
Right channel Equalizer indicators
2
1
STANDBY/ON switch ( ON)
STANDBY /
3 Equalizer controls
These are equalizer controls for the bands 60 Hz, 150 Hz, 400 Hz, 1 kHz, 2.4 kHz, 6 kHz and 15 kHz. When the EQUALIZER button has been set to ON, these controls may be adjusted. When a control is raised upwards from the �0� position, the frequency band corresponding to that control will be emphasized; when the controls is lowered, the frequency band will be attenuated. These controls can be used independently for right and left channels.
When this switch is set to the ON position, power is supplied to the unit�s main circuits (Equalizer indicators lights).
NOTE:
Even when performing playback without using the functions of this component, be sure that its STANDBY/ ON switch is ON. If the STANDBY/ON switch is STANDBY, no sound will be produced from the speakers.
NOTE:
In order to protect your speakers from damage resulting from excessively large inputs, whenever augmenting high-frequency sound over a wide range, be sure not to raise your amplifier�s sound volume too high.
2 EQUALIZER button (EQUALIZER ON)
OFF /
When this button is pressed, the equalizer ON indicator lights and its functions become operative. When pressed once again, this indicator goes out and the unit�s functions are turned OFF. Use this button in the following manner: ON: When using the equalizer to add sound compensation. OFF: When not using the equalizer, but playing back or recording program sources without compensation.
