JVC GR-D246EY
Instrukcja Obsługi

36 EN

EDITING
NOTES:
� It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 13) � If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed. � Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again. � If SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector. � When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

Dubbing To Or From A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

To use this camcorder as a recorder

1 Make sure all units are turned off. 2 Connect this camcorder to a video unit
To DV IN/OUT

equipped with a DV output connector using a DV cable as shown in the illustration.

3 Set the camcorder�s Power Switch to �PLAY�. 4 Set �REC MODE� to �SP� or �LP�. ( pg. 26) 5 Press the Recording Start/Stop Button to
engage the Record-Pause mode.
Core filter DV cable (optional) � The � DV IN � indication appears on the screen.

6 Start playback on the player.

7 At the point you want to start dubbing, press
the Recording Start/Stop Button to start dubbing. The indication rotates.
To DV IN/OUT

8 Press the Recording Start/Stop Button again
to stop dubbing. The rotating. mode. indication stops

9 Press 8 to return to the normal playback
Video unit equipped with DV connector

NOTE:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current �SOUND MODE� setting. ( pg. 23)

To use this camcorder as a player

1 Make sure all units are turned off. 2 Connect this camcorder to a video unit
equipped with a DV input connector using a DV cable as shown in the illustration.

3 Start playback on the camcorder. ( pg. 20) 4 At the point you want to start dubbing, start
recording on the video unit. (Refer to the video unit�s instruction manual.)

5 To stop dubbing, stop recording on the video
unit, then stop playback on this camcorder.