JVC GR-D47AC
Instrukcja Obsługi

EDITING EN

25

Dubbing To Or From A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

1 Make sure all units are turned off. 2 Connect this camcorder to a video unit equipped with
a DV input connector using a DV cable as shown in the illustration.

To use this camcorder as a player

3 Set this camcorder�s Power Switch to �PLAY� while
pressing down the Lock Button located on the switch. 4 Turn on the video unit�s power.

5 Insert the source cassette in this camcorder. 6 Insert the recording cassette in the video unit. 7 Press 4/9 on this camcorder to start playback of the
source cassette.

8 At the point you want to start dubbing, engage the
video unit�s Record mode.

9 To pause dubbing, engage the video unit�s RecordPause mode and press 4/9 on this camcorder.

10 Repeat steps 7 � 9 for additional editing. Stop the
To DV IN/OUT

video unit and camcorder.

NOTES:

Core filter

DV cable (optional)

To DV IN/OUT

� It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 7) � If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed. � Even though the DV cable is connected correctly, sometimes the image may not appear in step 8. If this occurs, turn off the power and make connections again. � If SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV connector. � When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

Video unit equipped with DV connector

To use this camcorder as a recorder 1) Perform steps 1 to 3 in �To use this camcorder as a player�. 2) Set �REC MODE� to �SP� or �LP�. ( pg. 14, 15) 3) Insert the recording cassette in this camcorder. 4) Press the Recording Start/Stop Button to engage the Record-Pause mode.
� The � DV. IN � indication appears on the screen.

5) Press the Recording Start/Stop Button to start recording. The T indication rotates. 6) Press the Recording Start/Stop Button again to stop recording. The T indication stops rotating.

NOTE:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current �SOUND MODE� setting. ( pg. 15)

ADVANCED FEATURES