Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
16
EN
90°
RECORDING Basic Recording (cont.)
Shooting While Watching The LCD Monitor
Before the following steps, perform step 1 ( pg. 14). Make sure the viewfinder is fully tilted downward and pushed back in. Set the Power Switch to the camera position (� �, � �, �5S� or � �) while pressing down the Lock Button located on the switch. Press PUSH-OPEN and open the LCD monitor fully. �The lens cover opens, the power lamp lights and the camcorder enters the Record-Standby mode. �The scene you are aimed at appears in the LCD monitor, with the word �PAUSE� superimposed upon it.
180°
2 ENTER RECORD�STANDBY MODE
PUSH-OPEN Button
3 START SHOOTING
Tilt the LCD monitor upward/downward for best viewability ( pg. 17) and press the Recording Start/ Stop Button. �� � appears in the LCD monitor while recording is in progress.
Recording Start/Stop Button
4 STOP RECORDING
NOTES:
Press the Recording Start/Stop Button again to stop recording. �The camcorder re-enters the Record-Standby mode.
Power lamp
AY OFF
P L
Power Switch
Tally lamp (lights while recording is in progress)
5S
Lock Button
� When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, we recommend that you use the viewfinder ( pg. 14). � To turn the tally lamp off during recording, refer to pgs. 28 and 30. � For other notes, refer to pg. 15.
