JVC GR-DVP7U
Instrukcja Obsługi

86 EN

TROUBLESHOOTING (cont.)

34. Colored bright spots appear all 34. � The LCD monitor and the 34. over the LCD monitor or the viewfinder are made with viewfinder. high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor or the viewfinder. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %) 35. The indicators and the image color on the LCD monitor are not clear. 36. The cassette will not load properly. 35. � This may occur when the surface or the edge of the LCD monitor is pressed. 36. � The cassette is in the wrong position. � The battery�s charge is low. 35.

�

� 36. � Set it in the right position. ( pg. 16) � Install a fully charged battery. ( pg. 10, 11) 37. � Set it in the right position. ( pg. 17) 38. � Push in the memory card a few more times. ( pg. 17)

37. The memory card will not load 37. � The memory card is in the properly. wrong position. 38. The memory card cannot be removed from the camcorder. 38. �

39. Picture does not appear on the 39. � The viewfinder is pulled out. 39. � Push the viewfinder back in. LCD monitor. � The LCD monitor�s brightness � Adjust the brightness of the setting is too dark. LCD monitor. ( pg. 13) � If the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 13) 40. Images on the LCD monitor are jittery. 40. � The speaker volume is too great. � 40. � Turn the speaker volume down. ( pg. 22) 41. � Wipe them gently with soft cloth. Wiping strongly can cause damage. ( pg. 91) 42. � Set �TIME CODE� to �ON�. ( pg. 38, 48, 51) 43. � Check the section of the manual that explains LCD monitor/viewfinder indications. ( pg. 96 � 99)

41. The LCD monitor, the 41. viewfinder and the lens have become dirty (ex. fingerprints). 42. Time code does not appear. 43. An unusual mark appears.

42. � �TIME CODE� is set to �OFF�. 43. �