|
|
|
Kto jest w sklepie?
Sklep przegląda 5896 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Dubbing To Or From A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from this camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
5. Press START/STOP k on the remote control to start recording. 4 rotates. 6. Press START/STOP k on the remote control again to engage the Record-Pause mode. 4 stops rotating.
NOTES:
� Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current �SOUND MODE� setting ( pg. 32). � During Digital Dubbing, incoming signals cannot be output through the video or audio connectors if they are copy-guarded.
To Use This Camcorder As A Player
1 Make sure all units are turned off. Connect this
camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
2 Set this camcorder�s VIDEO/MEMORY Switch t to �VIDEO�, then the Power Switch @ to � � while pressing down the Lock Button $ located on the switch, turn on the video unit�s power, and insert the appropriate cassettes in this camcorder and the video unit. 3 Press 4 ! to play back the source tape. 4 While watching the playback on the monitor, engage
the DV connector-equipped video unit�s record mode from the spot on the source tape you want to begin recording.
t ! $ @
NOTES:
� It is recommended to use the AC Adapter as the power supply instead of the battery pack ( pg. 7). � If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units. � If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed. � Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again. � If �Playback Zoom� ( pg. 13, 39), �Playback Special Effects� ( pg. 39) or �Snapshot� is attempted during playback, only the original playback image recorded on the tape is output from the DV connector ). � When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
To DV
)
Core filter DV cable (optional) Core filter
To Use This Camcorder As A Recorder
1. Set this camcorder�s VIDEO/MEMORY Switch t to �VIDEO�, then the Power Switch @ to � � while pressing down the Lock Button $ located on the switch. 2. Set �REC MODE� to �SP� or �LP� in the Menu Screen ( pg. 35). 3. Connect the DV cable as shown in the illustration and load a cassette to record on. 4. Press START/STOP k on the remote control to engage the Record-Pause mode. � DV. IN � appears on the screen.
Video unit equipped with DV connector
To DV IN/OUT
EN
38 DUBBING
|
|
|
> |
|
