INSTALLATION
Figure 5. Mounting the tweeter using the I-Mount flush-mounting kit.
blk red
1) push in 2) turn 3) 4)
CONNECTIONS
Open the crossover housing by firmly squeezing the sides of the top half and lifting it away from the bottom. Using screws or a wire tie, mount the crossover using the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in Figures 8A and 8B. Replace the cover when you are finished making the connections and adjustments (see following section). Figure 8A. Wiring connections on the crossover network (shown with cover on).
Big Lug =
Figure 8B. Locating wiring connections on the GTO506c woofer. Other woofers are wired similarly.
� +
Figure 6. Aiming the tweeter at a desired listening position.
3. Rotate to aim angled tweeter toward listener.
Small Lug =
1. Slide screw up or down to adjust tweeter angle.
2. Tighten nut and washer to lock angle settings.
To AMPLIFIER SPEAKER OUTPUTS
Red To TWEETER To WOOFER Blk
4. Securely tighten the large hand nut.
Figure 7. Mounting the tweeter using the I-Mount surface-mounting kit.
