|
|
|
Kto jest w sklepie?
Sklep przegląda 6043 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
GTX65 Guitar
DSP
The Front Panel: &
Amplifier
with
Channel Tracking
11
12
13
14
15
16
17
18
16: INSERT: Use this jack to connect an external effects device to the amplifier. Use a stereo 1/4� male Y connector: ring = send, tip = return, sleeve = ground. (Refer to the illustration at the bottom of page 5.) 17: EXTERNAL SPEAKER: Use this jack to connect the amplifier to an external speaker. This jack is wired in series with the internal speaker. 18: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch illuminates when the amplifier is on. 19: AC LINE CORD (rear panel, not shown): This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection. 20: FUSE (rear panel, not shown): The fuse protects the amplifier from damages caused by a faulty AC power source and/or other problems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to fail, check the AC source � if the source is okay, contact your Crate dealer for service information. 21: CHANNEL SELECT / GAIN FOOTSWITCH JACK (rear panel, not shown): Use this jack to connect the stereo 1/4� plug of the supplied three-button footswitch for remote control of channel and gain selections. 22: REVERB FOOTSWITCH JACK (rear panel, not shown): Use this jack to connect the mono 1/4� plug connected to the three-button footswitch (supplied) for remote control of DSP on and off. CONNECTING TO THE INSERT JACK:
Stereo-to-mono Y-cord: Y-adapter and 2 cables:
RETURN SEND GROUND TIP RING SLEEVE to Insert jack
TIP
The Insert jack (#16) allows you to patch an external effects device into the amplifier prior to its power amp stage. Use Crate�s STP201, STP202 or STP203 stereo-to-mono Y cord or an adapter such as Crate�s YPP117 and two 1/4� mono signal cables to connect the effect as shown in the adjacent illustration.
to Insert jack
TIP RING SLEEVE
(STP201, 3' STP202, 6' STP203, 9')
(YPP117)
R I N G
TIP
RING
(1/4"-TO-1/4" MONO CABLES)
to effect "OUT" jack
to effect "IN" jack
to effect "OUT" jack
to effect "IN" jack
External Effect
External Effect
5
|
|
|
> |
|
