Adjusting the gap between the stored edit-start point in the computer and the dubbed one in the recording deck
During dubbing, the beginning of the scene stored in the computer can be missed or the scene prior to the transition you chose for the edit-start point can be dubbed into the recording deck. When these cases occur, adjust the gap for more accurate editing.
1 CHECK EDIT-START TIMING
After dubbing ( dubbed scene.
pg. 52), play back the
4 DETERMINE VALUE
Click "OK". �This value is stored in the computer.
2 ACCESSDIALOG BOX CORREC- 5 CHECK EDIT-START TIMING "PAUSE TIME TION" AGAIN
Choose "Pause Time" from "File" on the MOVIE PLAYER window. �The "Pause Time Correction" dialog box appears. To check the corrected edit-start timing, dub the stored scenes and play them back.
3
ENTER VALUE
To adjust the edit-start timing, enter a new value from 0.00 sec. to 2.60 sec.
NOTE:
Even if the edit-start timing is adjusted, there can be a slight margin between the adjusted edit-start point and the dubbed scenes' one.
When the scene prior to the transition you chose for edit-start point is dubbed: Enter a smaller value than 1.30. When the beginning of the scene stored in the computer is missed: Enter a larger value than 1.30. �Factory preset is 1.30 sec..
MOVIE PLAYER
File Edit Video Printer Help New COUNTER Open Save POWER Save As...
Drop Ctrl+N 00:00:01:20F
Ctrl+O
ID 06
FILE travel
Pause Time Correction
MEMO Europe Tour SCENE START MODE
STILL PLAY SEARCH SLOW FF
ON Ctrl+S OFF
Ctrl+A
PROGRAM PLAYBACK
Type in the value from 0.00(sec) to 2.60(sec), to adjust pause time during editing. Pre-start time = 1.30 (sec)
ID Change Device Change SCENE Name Change 01 Pause Time... 02 Close Serial Initialize Counter Reset Exit
CUT IN 00:01:30:12F 00:07:15:21F Open VCR Control Window 03 00:15:50:11F