|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
6
Adjusting the cutting height
Adjusting the Cutting Height � Never use more than 2 cutting height spacers. � Spacers can only be fitted between the blade and the fan and never between blade and the bolt (R). 1. Ensure the Operator Presence Control is released, when the engine has stopped rotating - disconnect the spark plug lead. 2. Close the fuel tap (L). T urn your lawnmower on its side. 3. Remove the blade bolt (R1) and blade (R2) as described in �Removing the Blade and Fan�. 4. For a Lower Cut - Add spacers (R3) to a maximum of 2. 5. For a Higher Cut - Take spacers (R3) away. 6. Refit the blade as described in �Fitting the Blade and Fan�. How to Mow 1. Place the handle in the mowing position (C3). 2. Mow twice a week in the growing season. Y our lawn will suffer if more than one third of its length is cut at one time. � Keep hands and feet away from the blade, a rotating blade cannot be seen. � Mowing on banks and slopes can be dangerous. Do not mow on steep slopes. � Always keep your feet on flat ground with the mower below you on the slope and with the spark plug uppermost to avoid lubricating oil running into the cylinder. Do not use this mower on slopes which are wet or more than 450 from horizontal. Never push the mower up the slope.
R
4 9 3 8
2 7 1 5 6
� �
Removing & Fitting the Blade & Fan
WARNING � Always handle the blade with care - sharp edges could cause injury. USE GLOVES � Spark plug lead may be hot - handle with care. Removing the Blade and Fan � Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner regardless of condition. � If the blade is cracked or damaged replace it with a new one. 1. Ensure the Operator Presence Control is released, when the engine has stopped and the blade has stopped rotating - disconnect the spark plug lead. 2. Fully close the fuel tap (L). 3. Turn your lawnmower on its side with the air cleaner uppermost (see pic above). 4. To remove the blade bolt (R1), hold the fan (R4) firmly and with the spanner provided loosen the blade bolt by turning it anti-clockwise. 5. Remove the blade bolt (R1), blade (R2), spacers (R3) and fan (R4). 6. Inspect for damage and clean as necessary. Fitting the Blade and the Fan � Before using the lawnmower, always visually inspect to see that blades and bolts are not worn or damaged. � Never use more than 2 cutting height spacers. � Spacers can only be fitted between the blade and the fan and never between blade and the bolt. 1. Ensure the fan is located correctly. 2. Place the spacers (R3) onto the fan ensuring the pegs (R5) have located into the holes (R6). 3. Place the blade (R2) onto the spacers (R3) ensuring the pegs (R7) have located into the holes (R8) on the blade and ensuring the blade is positioned as illustrated in Figure R. 4. Place the blade bolt (R1) through the centre hole (R9) of the blade. 5. Tighten down clockwise by hand. 6. Hold the fan firmly and tighten the blade bolt with the spanner provided.
|
|
|
> |
|
