|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
HCD-CP101 SECTION 4 TEST MODE
[COLD RESET] � The cold reset clears all data including preset data stored in the RAM to initial conditions. Execute this mode when returning the set to the customer. Procedure: 1. Turn ON the power. 2. Press three buttons of x (TAPE), x (CD), and [BAND] simultaneously. 3. The set is reset. [LIQUID CRYSTAL DISPLAY ALL LIT CHECK MODE] Aging mode sequence: Procedure: 1. Set to standby state. 2. Press three buttons of x (TAPE), x (CD), and [TUNING MODE] simultaneously. 3. Liquid crystal display are all turned on. 4. To exit from this mode, press the I/1 button to turn the power OFF. [TAPE DECK AGING MODE] This mode can be used for operation check of tape deck section. Procedure: 1. Set a tape in the tape deck. 2. Set to standby state. 3. Press three buttons of x (TAPE), x (CD), and [TUNING +] simultaneously. 4. The aging is executed in bellow sequence. 5. To exit from the aging mode, press the I/1 button to turn the power OFF. Aging mode sequence:
Start
[CD AGING MODE] This mode can be used for operation check of CD section. Procedure: 1. Load a CD disc. 2. Set to standby state. 3. Press three buttons of x (TAPE), x (CD), and [TUNING --] simultaneously. 4. The aging is executed in bellow sequence. 5. To exit from the aging mode, press the I/1 button to turn the power OFF.
Open the disc tray
Close the disc tray
Play the last track
Start
[CHANGE-OVER MD/VIDEO] Procedure: 1. Set to standby state. 2. Press the x (CD) and the [FUNCTION] buttons simultaneously. The function changes over to MD or VIDEO by turns. [CHANGE-OVER THE AM TUNING INTERVAL] (EXCEPT AEP and UK models) � The AM tuning interval can be changed over 9 kHz or 10 kHz. Procedure: 1. Press the I/1 button to turn the power ON. 2. Select the function �TUNER�, and press the [BAND] button to select the BAND �AM�. 3. Press the I/1 button to turn the power OFF. 4. Change over to 9 kHz: Press the [TUNING --] and the x (CD) buttons simultaneously. Change over to 10 kHz: Press the [TUNING +] and the x (CD) buttons simultaneously.
FWD Play 1 minute REC pause for 3 seconds
Shut off
FWD REC 3 minutes Fast forward
Shut off
REV Play 1 minute REC pause for 3 seconds
Shut off
REV REC 3 minutes Rewind
Shut off
12
|
|
|
> |
|
