SONY HCDDP700
Instrukcja Serwisowa

HCD-DP700

6. When the check is complete, a message of either OK or NG appears. * To return to normal mode again. 1. When you want to exit this mode, press the POWER button. 2. The cold reset is enforced at the same time. [Aging Mode] This mode can for operation check of tape deck section and CD section. � If an error occurred: The aging operation stops and display then status. � If no error occurs: The aging operation continues repeatedly. Procedure: 1. Press the CD button to select the function �CD�. 2. Load the tapes into the decks A and B respectively. 3. Set a disk in �DISK1� tray. 4. Press the PLAY MODE button to set the �ALL DISCS� mode, and press the REPEAT button to �REPEAT� off. 5. Press three buttons of STOP , ENTER , and DISC SKIP/EXCHANGE simultaneously. 6. The aging mode is activated, if the indicator of DOLBY NR is blinking. 7. To exit from the aging mode, operate the cold reset.

[Tape Deck Section] � The sequence during the aging mode is following as below. � If an error occurred, stop display that step. Aging mode sequence (Tape deck section): Rewind the tape A and B �TAPE A AG-1� Shut off FWD play the tape A �TAPE A AG-2� 2 minutes Fast forward the tape A �TAPE A AG-3� Shut off or 20 seconds RVS play the tape A �TAPE A AG-4� 2 minutes Rewind the tape A �TAPE A AG-5� Shut off FWD play the tape B �TAPE B AG-2� 2 minutes Fast forward the tape B �TAPE B AG-3� Shut off or 20 seconds RVS play the tape B �TAPE B AG-4� 2 minutes Rewind the tape B �TAPE B AG-5� Shut off

14