SONY HCDXB20
Instrukcja Serwisowa

TUNER SECTION

0 dB=1µV

AM Tuning Voltage Adjustment
Main board TP1 F G VT DC voltmeter

+ �

Procedure: 1. Set the reception frequency of the unit to 530 kHz. 2. Adjust L105 for 1.2 ± 0.05 V reading on the DC voltmeter. 3. Set the reception frequency of the unit to 1,710 kHz. 4. Confirm that the voltage reading on the DC voltmeter is within 8.0 ± 0.5 V. Adjustment Location: MAIN board (See page 14) AM Tracking Adjustment
loop antenna loop antenna (Supplied accessories)

AM RF SSG set 30% amplitude modulation by 400 Hz signal AM ANTENNA terminal (TM1)

60 cm

Field strength dB (µV/m) =SSG output level dB (µV/m) �26 dB.

Procedure: 1. Tune the set to 600 kHz. 2. Set the output of AM RF SSG so that the input level of the set will become 60 dB (µV/m). 3. Adjust L104 so that when the waveform on the oscilloscope is maximum, no noise appears. 4. Tune the set to 1,400 kHz.

5.

Adjust TC102 so that when the waveform on the oscilloscope is maximum, no noise appears.

� Repeat the procedures in each adjustment several times, and the tracking adjustment should be finally done by the trimmer capacitors. Adjustment Location: MAIN board (See page 14)

FM Tuning Voltage Adjustment (US, Australian, Mexican model)
Main board TP1 IF G VT DC voltmeter

+ �

Procedure : 1. Set the reception frequency of the unit to 87.5 MHz. 2. Adjust L103 for 1.2 ± 0.05V reading on the DC voltmeter. 3. Set the reception frequency of the unit to 108 MHz. 4. Confirm that the voltage reading on the DC voltmeter is within 7.8 ± 0.5V. Adjustment Location: MAIN board (See page 14)

� 13 �