Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 18 (kliknij aby zobaczyć)
� Fix the base spacer M to the wall with the two screws R 5x45 provided using either the long or the short arm, depending on the depht of the side cupboards. Do not tighten the screws fully. Fig. 11. � Fix the hood to the wall by means of the two hooks P previously mounted, but first move the upper brackets S so that the front panel of the hood, once mounted, will be in line with the front edge of the cupboard doors. The two upper brackets S, located at the top rear edge of the hood may be slid backwards and forwards by loosening its fixing screws T adjacent to them on the upper hood surface. Fig. 11. � Check that the hood is at the right height. Minor height adjustments may be made with the screws U embodied in the brackets. Fig. 11. � Tighten the two wall fixing screws R, through the two access holes N provided on the inside of the hood then fix the lower sliding frame to the hood with two screws O and washers. Fig. 11.
Fixing a furniture door to the visor
Before fixing the furniture door to the visor, please ensure the distance distance between the plate and the upper edge of the cabinet door is correct (depends on the thickness of the material and whether or not there is an upper shelf). Fig. 6.
b
a b 0 = 17 16 = 33 19 = 36
a
Fig. 12
� Remove the grease filters. Fig. 3. � Take off the visor G by turning the rear locking knobs H. Fig. 13.
