|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
62
Convenient recording of CD player output
Program recording (PGM mode + O.T.E.) (Norm)
CD = CDR
The Twin Recording makes is possible to record desired CD tracks programmed in the desired order onto a CD-R/RW simultaneously. (High-speed recording is not available.) The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with certain discs.�Digital recording and SCMS� A
Select the �CD� input. Be sure to put the CD recorder in stop mode. Before recording
DIGITAL
When digital-to-digital recording is not impossible or when analog-to-digital recording is performed, select the analog input as described in the following section then start the setting from step 1 below.�Changing the recording input setting�e
The current setting is displayed. "DIGITAL" is lit ............. Digital-to-digital recording "DIGITAL" not lit: ......... Analog-to-digital recording
1 Make the preparations for recording.
1 Place a recordable CD-R or CD-RW disc. � 2 Load the recording source disc in the CD player. ¢ 3 Make sure that the "High" (high-speed dubbing indicator) in the display is not lit.
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN indicator may blink for a while. �OPC (Optimum Power Control)� � ÷ If the "HIGH" is lit in the display, turn it on by selecting "O.T.E. Speed" in the menu mode, selecting "<Norm>" and pressing the SET key.
2 Check the current play mode of the CD player.
If it is in play mode, stop it.
7
3 Program the desired sequence of CD tracks.
Perform steps 2 and 3 of the procedure in �Listening in the desired sequence (Program playback)�. u
4 Start recording.
CD=CDR
Knowledge Application Basic Preparation section
÷ High-speed recording is not available in the PGM mode. ÷ Recording starts with the first programmed track until all the programmed tracks have been recorded. ÷ When either the CD program playback or CDR recording operation stops, the other operation also stops. ÷ When you are operating the main unit, select "O.T.E. Mode" in the menu mode, then select "CD=CDR <Norm>" and = press the SET key to start recording. ÷ With certain discs, digital-to-digital recording may be prohibited by SCMS (A). Such a disc should be recorded using the analog output signal. e
|
|
|
> |
|
