Recording
Use the following procedure to record TV programmes on a blank video tape.
Editing
Editing To/From Another Recorder
Player
Before proceeding:
� To record TV programmes, the video cassette player must be connected to the TV as shown in connection B of the �Connections� section. � Turn on the power of the TV and video cassette player. � Make sure that the video cassette�s safety tab is intact. If it has been removed, cover the hole with adhesive tape.
40 32 10-
RF OUT
K G AUDIO
IN
OUT
ANT. IN
1-
VIDEO
Audio/Video signals
1
INTELLIGENT PICTURE
OPERATE STANDBY
2
NTSC ON PAL TV NTSC3.58 NTSC4.43
PAL NTSC
- VOLUME + TV/VIDEO TVCH
TV
+ OPERATE
VIDEO
TV/VIDEO OPERATE
AUTO
- TRACKING +
2
(+
SP/LP/EP
NTSC 3.58/4.43
RECORDING & PLAYBACK
INTELLIGENT PICTURE
LP/EP
L
+(
40 32
10-
[
J
RF OUT
K G AUDIO
IN
OUT
ANT. IN
1-
VIDEO
REMOTE CONTROL UNIT
Recorder
1 2
Load a blank video tape. Press the Record ¶ button to start recording. (On the remote control unit press the Record ¶ and Play 3 button at the same time.) The recording indicator will light during recording.
TV Receiver VIDEO CHANNEL
1 2 3
Connect the player�s AUDIO and VIDEO OUT connectors to the recorder�s AUDIO and VIDEO IN connectors. Put the player in the Play mode. Put the recorder in the Record mode.
7 Press the Stop/Eject § button or the remote control�s Stop & button to stop recording. To stop recording temporarily: 7 Press the Pause 8 button. The recording indicator will blink. Press the Play 3 button to resume recording. Notes: � To engage recording standby, press the Record ¶ button and then press the Pause 8 button. The recording indicator will blink during recording standby. Press the Play 3 button again to start recording. � If the Record button does not work, check to see if the cassette safety tab has been removed. � The player automatically stops when record-standby continues for more than 5 minutes. � The video tape will be rewound automatically when the end of the tape is reached.
Notes: � NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder. � When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch. Important: 7 To edit, both the player and the recorder must be of the same colour system. Press your recorder�s Colour system switch to select the appropriate colour system.
