JVC HR-VP655U
Instrukcja Obsługi

EN

21

C H

7 8
OK

ACCESS DBS RECEIVER BRAND SET SCREEN
Press OK.

SET DBS RECEIVER BRAND
Press the appropriate NUMBER keys to enter the DBS Receiver Code from the following list, then press OK.
DBS RECEIVER BRAND SET 40

PRESS NUMBER KEY (0�9) THEN (OK) TO TEST PRESS (MENU) TO END

BRAND JVC (DISH Network) ECHOSTAR (DISH Network) PRIMESTAR SONY (DSS) RCA (DSS)

CODE 51 51 50 41 40

1
NUMBER

2 5 8 0

3
2

4 7

6 9
4

� After OK is pressed, the program currently received through the DBS receiver will appear for about 10 seconds. � If the DBS receiver's channel changes as follows, setting is complete. Press OK and "DBS RECEIVER CONTROL IS ON" appears on the screen for about 5 seconds, then it returns to the normal screen. JVC [ 100 ECHOSTAR [ 100 PRIMESTAR [ 55 SONY [ 205 RCA [ 205 � If the DBS receiver's channel does not change as shown above, press CH 5� or SHUTTLE PLUS %� to move the highlight bar (arrow) to "NO", then press OK. Re-enter the correct code.

1

3

OK

SHUTTLE PLUS

NOTES:
� It is possible that the Controller will not work with all types of DBS receiver. � If your DBS receiver doesn�t respond to the code, you can�t use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording. � The VCR can only change the satellite channel through the Controller during timer recording. � If your DBS receiver is one that can�t be operated with a remote control (because it has no remote sensor), you can�t use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording. � For customers in U.S.A.: If you are unable to set the Controller, please contact JVC toll free at 1-800-252-5722.