JVC HRXVC29SUS
Instrukcja Serwisowa

3.2

Loading mechanism assembly

3.2.1 Removing the tray (See Figure 3-2a, Figure 3-2b, Figure 3-2c, Figure 3-2d, Figure 3-2e, Figure 3-2f) (1) Push a of the slide cam on the hole in the right side of the Tray loading base by using a driver until it stops. (See Figure 32a.) (2) The tray comes out. Pull the tray in a front direction until it stops. (3) Remove the two screws A attaching the slide bracket. (See Figure 3-2b.) (4) Tilt the tray in a direction of the arrow around the point in the left rear part of the tray. (See Figure 3-2c.) (5) The rail of the tray is removed from b of the loading base. Then, remove the tray upward. (See Figure 3-2d.) Attaching the tray: Engage c of the loading base to the projection of the tray while tilting the tray to the left. Turn the tray in a direction of the arrow, and attach the slide bracket. (See Figure 3-2e.) Note: Prior to the procedure above, move the slide cam in a direction of the arrow so that d of the slide cam can be inserted in e of the tray. (See Figure 3-2f.)

The point in the left rear part Fig.3-2c

Tray

Loading base part b

Rail of the tray

Fig.3-2d

Push Slide cam part a Fig.3-2a Loading base Projection of the tray Tray

A

Slide bracket

A

Loading base part c
Fig.3-2e

Part e
Fig.3-2b

Part d

Slide cam
Fig.3-2f

1-12 (No.YD052)